Cub Cadet 3x28 Manual del operador descargar pdf (Pagina 23)

Se rvi ce

Belt Replacement

Auger Belt

To remove and replace your snow thrower’s auger belt, proceed

as follows:

1. Allow the engine to run until it is out of fuel. Do not

attempt to pour fuel from the engine.

2. Remove the plastic belt cover on the front of the engine by

removing the two self-tapping screws. See Figure 7-1.

Figure 7-1

3. Roll the auger belt off the engine pulley. See Figure 7-2.

Figure 7-2

4. Carefully pivot the snow thrower up and forward so that it

rests on the auger housing.

5. Remove the frame cover from the underside of the snow

thrower by removing the self-tapping screws which secure

it. See Figure 7-3.

Figure 7-3

6. Loosen and remove the shoulder bolt which acts as a belt

keeper. See Figure 7-4.

Figure 7-4

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Cub Cadet 3x28 Manual del operador Pagina 23