Cub Cadet 3x28 Manual del operador descargar pdf (Pagina 11)

11Section 3 — ASSembly & Set-Up

NOTE: Make certain the cables are seated properly in the

roller guides. See Figure 3-13.

Figure 3-13

5. Reattach the two carriage screws and lock nuts removed

earlier as shown in Figure 3-14.

Figure 3-14

6. Finish securing the handle by tightening the top two lock

nuts loosened earlier. Remove and discard any remaining

rubber bands, if present. They are for packaging purposes

only.

Chute Assembly

1. Remove the lock nuts and hex screws from chute support

bracket. Position the chute assembly over the chute base.

See Figure 3-15.

Chute

Assembly

Chute Base

Chute

Support

Bracket

Chute Control

Head

Figure 3-15

2. Place chute assembly onto chute base.

3. Secure chute control head to chute support bracket with

the lock nuts and hex screws removed earlier. See Figure

3-16.

Figure 3-16

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Sin comentarios

Cub Cadet 3x28 Manual del operador Pagina 11