Cub Cadet 526 SWE Manual del operador descargar pdf (Pagina 11)

Chute Assembly

NOTE: Chutes on models with 4-Way Chute Control are

controlled by the Chute Directional Control. See Fig. 4-1.

The distance snow is thrown can be adjusted by changing the

angle of the chute assembly. To do so:

Stop the engine. Refer to the Engine Operator’s Manual. 1.

Remove the key

Loosen the plastic knob found on the left side of the chute 2.

assembly.

Pivot the chute upward or downward before retightening 3.

the wing knob. See Fig. 3-15.

Auger Control

WARNING! Prior to operating your snow thrower,

carefully read and follow all instructions below.

Perform all adjustments to verify your snow thrower

is operating safely and properly.

Check the adjustment of the auger control as follows:

When the auger control is released and in the disengaged 1.

“up” position, the cable should have very little slack. It

should NOT be tight.

In a well-ventilated area, start the snow thrower engine. 2.

Refer to the Engine Operator’s Manual packed with your

snow thrower.

While standing in the operator’s position (behind the snow 3.

thrower), engage the auger.

Allow the auger to remain engaged for approximately ten 4.

(10) seconds before releasing the auger control. Repeat this

several times.

With the throttle control in the FAST (rabbit) position and 5.

the auger control in the disengaged “up” position, walk to

the front of the machine.

Confirm that the auger has completely stopped rotating 6.

and shows NO signs of motion. If the auger shows ANY

signs of rotating, immediately return to the operator’s

position and shut off the engine. Wait for ALL moving parts

to stop before re-adjusting the auger control.

To readjust the control cable, loosen the upper hex screw 7.

on the auger cable bracket. See Fig. 3-14.

Position the bracket upward to provide more slack (or 8.

downward to increase cable tension).

Retighten the upper hex screw.9.

Repeat steps 2 through 6 above to verify proper 10.

adjustment has been achieved.

Figure 3-14

Figure 3-15

11se c t i O n 3 — as s e M b l y & se t -up

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comentarios a estos manuales

Stephen J Knowlton 09 Feb 2025 | 01:43:17

Thank you!

Cub Cadet 526 SWE Manual del operador Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Lanzadores de nieve Cub Cadet 526 SWE