Cub Cadet 933 SWE Manual del operador descargar pdf (Pagina 21)

10. Slide the hex shaft through the right side of the frame

toward the left side and through the friction wheel

assembly.

NOTE: If the sprocket fell from the snow thrower chain while

removing the hex shaft, position the hex hub of the sprocket

toward the friction wheel and place the sprocket in the chain.

11. After making certain that the chain is on both the large

and the small sprocket, align the hex shaft with the hex

hub of the small sprocket, and slide the shaft through the

sprocket.

12. Slide the spacer onto the end of the hex shaft.

13. Align the bearing on the right end of the hex shaft with the

hole in the right side of the frame, then push the hex shaft

to the left into position in the frame.

14. Slide the bearing onto the left end of the hex shaft and

press into the hole on the left side the frame.

15. Place the belleville washer (rounded side toward head)

onto the hex screw removed earlier, and insert the screw

into the threaded hole of the hex shaft.

16. Using a 3/4” wrench holding the hex shaft, gradually

tighten the hex screw to fully seat the bearings in each side

of the frame and to secure the hex shaft.

17. Position the frame cover on the bottom of the frame and

secure with the self-tapping screws, and re-install the

right wheel. Pivot the snow thrower down to its normal

operating position.

IMPORTANT: Repeat the drive control test from the Assembly

& Set-Up section of this manual before operating the snow

thrower.

5. Holding the friction wheel assembly, slide the hex shaft out

of the right side of the frame. The spacer on the left side

of the hex shaft will fall and the sprocket should remain

hanging lose in the chain.

6. Lift the friction wheel assembly out between the axle shaft

and the drive shaft assemblies.

7. Remove four screws securing the friction wheel to the hub

assembly (refer to Figure 7-11). Discard old friction wheel.

Figure 7-11

8. Reassemble the new friction wheel onto the hub assembly,

tightening the four screws in rotation to 6-9 ft.-lbs. It is

important to assemble the friction wheel symmetrically for

proper functioning. Refer to Figure 7-11.

9. Reposition the friction wheel assembly in the snow thrower

frame. Insert the pin from the shift arm assembly into the

friction wheel assembly and hold assembly in position.

Refer to Figure 7-12.

Figure 7-12

21Section 7 — Service

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios

Cub Cadet 933 SWE Manual del operador Pagina 21

Comentarios a estos manuales

Relacionado con productos y manuales para Lanzadores de nieve Cub Cadet 933 SWE