Cub Cadet 933 SWE Manual del operador descargar pdf (Pagina 18)

Belt Replacement

Belt Removal Preparation

1. Remove the chute crank rod from the chute crank assembly by

removing the hair pin clip shown in Figure 7-1. Move the chute

crank rod away from the assembly as shown.

Figure 7-1

2. Remove the plastic belt cover on the front of the engine by

removing the three self-tapping screws. See Figure 7-2.

Figure 7-2

3. Loosen the bolt shown in Figure 7-3 securing the belt keeper

bracket and remove the other bolt. Push the belt keeper

bracket up off the engine pulley. See Figure 7-3.

Loosen

Remove

Figure 7-3

Auger Belt Replacement

To remove and replace your snow thrower’s auger belt, proceed

as follows:

1. Remove the bow-tie clip and flat washer from the ferrule

in order to disconnect the auger idler rod from the brake

bracket assembly. See Figure 7-4.

Ferrule

Auger Idler Rod

Bow-tie Clip

and Washer

Figure 7-4

NOTE: Make sure to maintain the location of the ferrule on

the idler rod.

2. Slip the auger control belt (the front belt) off the engine

pulley.

Se rvice

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Sin comentarios

Cub Cadet 933 SWE Manual del operador Pagina 18