Cub Cadet 221 HP Manual del operador descargar pdf (Pagina 9)

9Section 3 — ASSembly & Set-Up

3. Align the holes in the chute base with the holes in the

lower chute and secure with the previously removed hex

washer screws. See Figure 3-6.

Figure 3-6

Installing the Chute Rotation Control Assembly (Model 221 LHP only)

1. Remove the four hex washer screws from the back of the

handle (two on each side). See Figure 3-7.

Figure 3-7

2. Using the four hex washer screws, install the chute rotation

control assembly. See Figure 3-8.

Figure 3-8

3. Remove the screw and hex lock nut from the universal

joint. See Figure 3-9.

Universal Joint

Screw

Hex Lock Nut

Chute Rod

Figure 3-9

NOTE: Make sure the chute is facing forward when

installing the universal joint.

4. Install the universal joint on the end of the chute rod as

shown in Figure 3-9.

NOTE: Be sure the holes in the universal joint line up with

the holes in the chute rod. You may have to activate the

trigger to allow you to line up the holes.

5. Secure the universal joint with the hex nut and screw

previously removed. See Figure 3-9.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Sin comentarios

Cub Cadet 221 HP Manual del operador Pagina 9