search

Cub Cadet TANK 60 Manual del operador Pagina 33

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 48
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
    •
  • MARCADORES
    • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 32
33se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s
The right front blade tip height is fixed so you must adjust 5.

6.
jam nut.
Front to Back Leveling
Measure the blade-to-ground height at the right rear blade 
tip. Again be sure to measure at the blade tip at the rear of
the right blade when aligned along the mower centerline.
The blade-to-ground height at the rear of the blade tip
should be ⁄” to ⁄” higher than the front tip. This is referred
to as blade pitch. The same height difference should be
true for the left blade, measured front and back. The pitch
should not exceed ⁄⁄”.
Loosen the inner jam nuts at the rear left and right of the 2.

6.
ensure engine is operating properly.
Drive the tractor without a load to make certain all the 7.
tractor systems are functioning properly.
Adjustments
Adjusting the Seat

adjusting the seat.
Adjusting Drive Control Levers

adjusting the drive control levers.
Leveling the Mower Deck
When correctly adjusted the mower deck should be level side to
side, and the front of the deck should be approximately ⁄” lower
than the rear of deck.
NOTE: 

inflation pressures.
Side to Side Leveling

parking brake, shut off the engine, remove the key from the
ignition switch, disconnect the spark plug wires and using
the power implement lift, position the mowing deck into
the 4” height of cut position. (The 4” height of cut position
is recommended in order for one to see and obtain a
measurement. Any height of cut position is acceptable as
long as a proper measurement can be taken.)
Measure blade-to-ground height at the front tip of the 2.
right blade. To obtain an accurate measure, align blades in
parallel with mower centerline, (i.e. front to back).
Measure blade-to-ground height at the front tip of the left 

arranged in proper position.
Adjust the eyebolt at the left front of the deck so that the 4.
blade-to-ground height at the right front blade tip matches
that of the left front blade tip. This is done by loosening the
jam nuts on the eyebolt and tightening the upper nut to
raise the deck and loosening the nut to lower the deck.
Figure 6-5
Figure 6-6
Vista de pagina 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 47 48

Comentarios a estos manuales

Sin comentarios
Relacionado con productos y manuales para Tractor Cub Cadet TANK 60
Tractor Cub Cadet RZT L 50 KH Manual del operador    (80 paginas)
Tractor Cub Cadet 7532 Manual del operador   (126 paginas)
Tractor Cub Cadet C470 Manual del operador   (28 paginas)
Tractor Cub Cadet RZT 54 Manual de usuario   (2 paginas)
Tractor Cub Cadet 3165 Manual de usuario   (60 paginas)
Tractor Cub Cadet 5234D Manual del operador   (48 paginas)
  • Home Fashion Technologies Argom Tech Volvo Penta Strong Xaoc-devices
  • Netgear Routers Intel Barebones Pc / Estación De Trabajo RIDGID Taladros Eléctricos Pioneer Unidades de disco óptico Sony Los monitores crt
  • Sony DAV-S880 Philips CED750/98 Sony XS-FB1030 Sony bloggie MHS-TS55
  • Philips SHC8565 Instrucciones de operaciones Buick 2014 Encore Car Información técnica Nevion Multicon Manual de usuario Meade TE636W Manual de usuario