Cub Cadet RZT50 Manual del operador descargar pdf (Pagina 10)

Position Drive Control levers

The drive control levers of the tractor are lowered for shipping

purposes. The flange lock nuts, hex screws, and flat washers that

normally secure the control levers in their operating position

are unfastened and installed in the slotted holes of the control

levers for shipment. The control levers must be repositioned to

operate the tractor. To reposition the control levers for operation,

proceed as follows:

Remove the hex screw, flat washer, and flange lock nut 

from the slot of one of the drive control levers.

Lift and swing that control lever upward until the slotted 2.

hole in the lever bracket aligns with one of the holes in the





insert the hex screw with washer through the control lever





Note the relative position of the control lever to the pivot 4.

bracket, then repeat the previous steps to reposition the

other control lever in approximately the same position.

5.



adjustment of the levers.

Control Lever

Flange

Lock Nut

Slotted Hole

Washer

Hex Screw

Lift Control

Lever Upward

Pivot

Bracket

Figure 3-4

Connecting the Battery Cables

CALIFORNIA PROPOSITION 65 WARNING!



contain lead and lead compounds, chemicals known



reproductive harm. Wash hands after handling.

CAUTION: When attaching battery cables, always





For shipping reasons, both battery cables on your equipment

may have been left disconnected from the terminals at the

factory. To connect the battery cables, proceed as follows:

NOTE: 

negative battery terminal is marked Neg. (–).

NOTE: If the positive battery cable is already attached, skip

ahead to step 2.

Remove the plastic cover, if present, from the positive 

battery terminal and attach the red cable to the positive



Remove the plastic cover, if present, from the negative 2.

battery terminal and attach the black cable to the negative





terminal to help protect it from corrosion.

NOTE: If the battery is put into service after the date shown

on top/side of battery, charge the battery as instructed in the



the tractor.

Figure 3-5

10 se c t i O n 2— as s e M b l y & se t -up

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Comentarios a estos manuales

Sin comentarios

Cub Cadet RZT50 Manual del operador Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Tractor Cub Cadet RZT50