Cub Cadet CC3075 Manual del operador descargar pdf (Pagina 7)

Section3

Assembly

Shaft Grip

(4) Screws =_ _ _1_

Shaft ==

Housing ==

Minimum 6 inches

(15i24 cm)

D-Handle

Bottom Clamp

(4) Nuts .......

Fig,3-1 (if used)

Install and Adjust the D-handle

1. Remove the screws and bottom ciamp piece that

were installed on the D-handle for shipping.

2. Place D-handle over the shaft housing and onto the

bottom clamp (Fig. 3-1). Place it a minimum of 6

inches (15.24 cm) from the end of the shaft grip.

3. Start screws with a large Fiat-head or T-25 Torx

screwdriver. Do not tighten until you make the

handle adjustment.

4. If it was pre-installed, loosen the screws on the

D-handlejust enough to move the D-handle.

5. While holding the unit in the operating position

(Fig. 3-2), move the D-handle to the location that

provides you the best grip.

6. lighten the clamp screws evenly, until the D-handle

is secure.

Fig. 3-2

¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸¸7¸

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Sin comentarios

Cub Cadet CC3075 Manual del operador Pagina 7