Cub Cadet 7264 Manual del operador

SERIES 7000CUB CADET LLC P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 [www.cubcadet.com]IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLYWarning

10NOTE: References to LEFT and RIGHT indicatethat side of the tractor when facing forward whileseated in the drivers seat. Reference to FRONTindicate

11H. Differential Lock PedalFigure 6 Located at the rear of the left floor board, thedifferential lock pedal engages the transmissiondifferential lo

12M. Instrument PanelFigure 10 1. Fuel GaugeThe fuel gauge, located on the left side of theinstrument panel, monitors the fuel level in the fueltank

13FENDER MOUNTED CONRTOLS AND FEATURESFigure 11 ABNDEFGHKJHJKLGCMA. Fuel Fill CapThe fuel fill cap is located on the left fender besidethe operator’

14E. Transmission Hi/Lo Range Shift LeverThe Hi/Lo range shift lever is located on the rightfender. The lever has two speed range settings anda neutr

15SECTION 2: OPERATIONROLLOVER PROTECTIVE STRUCTURE (ROPS)This tractor is equipped with a foldable RolloverProtection Structure (ROPS) and seat belts

16SAFETY INTERLOCK SYSTEMThis tractor is equipped with a safety interlocksystem for the protection of the operator. If theinterlock system should eve

17STARTING THE ENGINEWARNING: Always sit in the operator’sseat when starting the tractor, Neverattempt to start the engine whilestanding beside the t

18DRIVING THE TRACTORWARNING: Avoid sudden starts, exces-sive speed and sudden stops.WARNING: Do not leave the seat of thetractor without disengaging

19Figure 15 WARNING: The forward/reverse pedalwill not operate when the parking brakeis engaged. Do not attempt to force thepedal when the parking b

2TABLE OF CONTENTSTO THE OWNER ...

20USING THE HYDRAULIC LIFT LEVERThe hydraulic lift system provides power for raisingand positioning three point hitch and belly mountedequipment. The

21Figure 20 • Push the bottom of the switch downward todisengage the PTO.IMPORTANT: Normally the PTO will notoperate when the tractor is driven in

22USING THE THREE POINT HITCHWARNING: Always disengage the PTO,stop the engine, and set the parkingbrake before dismounting the tractor toconnect, di

23Figure 24 ON DEMAND FOUR WHEEL DRIVEThe On Demand Four Wheel Drive systemautomatically delivers power to the front axlewhenever the need for addit

24SECTION 3: ADJUSTMENTSADJUSTING THE SEATFor the comfort of the operator, a single leveradjustable seat is provided to set the fore to aftposition o

25• The length of the upper hitch link is normallydetermined by the design of each implement.To adjust the upper hitch link, loosen the lock-ing leve

26ADJUSTING THE BRAKESThe tractor brakes are adjusted at the factory andshould experience minimal wear if the tractor isoperated normally. However, a

27SECTION 4: MAINTENANCEThe service life and reliability of any machinedepends upon the care it is given. Proper lubrica-tion and maintenance is a vi

28LUBRICATION AND MAINTENANCE CHART (ILLUSTRATION)11191253455866791014141712181613161616151821209

29LUBRICATION AND MAINTENANCE CHART† More often when operating under dusty conditionsRef.No.Operation tobe PerformedService IntervalsBeforeeach useEv

3www.cubcadet.comCUB CADET LLCP. O. BOX 361131CLEVELAND, OH 44136DEALER LOCATOR PHONE NUMBER: 877-282-8684Model Number Mfg. DateXXXXXXXXXXX XXXXXXXXX

30ACCESSING THE ENGINE COMPARTMENTWARNING: If the tractor has beenrecently operated, engine surfaces(including the radiator) will be HOT.Allow the en

31• Because battery acid is corrosive, do not pour itinto any sink or drain. Before discarding anempty electrolyte container, rinse it thoroughlywith

32HEAD LIGHT BULB REPLACEMENTThe tractor is equipped with four headlight bulbs. Ifone of the bulbs should burn out, replace the bulbas follows:• Full

33INSTRUMENT PANEL BULB REPLACEMENTReferring to the instrument panel information pro-vided in the CONTROL AND FEATURES sectionof this manual, regular

34Main FuseThe main fuse in the tractor wire harness protectsthe tractor’s entire electrical system. A blown mainfuse will prevent battery current fr

35• If the oil level is low, add Cub Cadet hydraulicoil. Loosely position a funnel in the fill hole sothat there is enough clearance around the fun-n

36CHANGING HYDROSTATIC TRANSMISSION AND HYDRAULIC SYSTEM OIL FILTERSNOTE: With the exception of the first oil filterchange after the 25 hour break-i

37CHECKING OIL LEVEL IN FRONT AXLE AND FINAL REDUCTION GEAR CASES.Check the front axle and final reduction gear caseoil levels after every 50 hours o

38• Place a suitable container beneath the front ofthe axle housing.• Remove the oil fill plug/dipstick to help vent theaxle, then remove the drain p

39TIRE MAINTENANCECheck the tire air pressure after every 50 hours ofoperation or weekly. Keep the tires inflated to therecommended pressures. Improp

4IMPORTANT SAFE OPERATION PRACTICESWARNING: THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IFNOT FOLLOWED, COULD ENDANGER THE PERSONAL S

403. Clean the engine and the entire tractorthoroughly.4. Fill the fuel tank with FRESH high gradeNumber Two diesel fuel.5. Remove the glow plugs and

41SECTION 5: ENGINE INFORMATION AND MAINTENANCEDaihatsu L.L.C., the California Air Resources Board (CARB)and the United States Environmental Protecti

42c. Ignition SystemFor Gasoline For Diesel• Spark plug(s) • Glow plug• Ignition coil• Ignition processord. Exhaust System• Exhaust manifolde. Miscel

43ENGINE MAINTENANCEWARNING: Use care when servicingany component in the engine area. Ifthe engine has recently been operated,components will be hot

44ADDING ENGINE OILWARNING: Never overfill the enginecrankcase. The engine may overheatand/or damage may result if thecrankcase is below the “ADD” ma

45• Remove the filter by turning it counterclockwiseusing an automotive type filter wrench toloosen. See Figure 56.Figure 56 • Reinstall the drain p

46• Start the engine and allow it to run for a shortperiod. Stop the engine.• Recheck the coolant level in the overflowreservoir and refill as needed

47• Pull the air cleaner element from the housing.See Figure 59.Figure 59 • Lightly blow or brush loose debris from the aircleaner element. Clean an

48Changing The Fuel FilterReplace the fuel filter cartridge after every 600hours of operation.NOTE: There is no shut off valve in fuel system. Tostop

49SECTION 6: SPECIFICATIONSEngineManufacturer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

5• Maintain the weight balance of the tractor.Install front end weights to counterbalanceheavy implements attached to the three pointhitch. Do not op

50SPECIFICATIONS Hydraulic Lift SystemType . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

51SECTION 7: OPTIONAL EQUIPMENT AND ACCESSORIESWhen purchasing your tractor, you probably had it equipped for your particular needs at that time.You

Proper maintenance of your Cub Cadet equipment is the owner’s responsibility. Follow the instructions in your owner’smanual for correct lubricants and

6• To prevent injury, do not adjust, unclog, clean,or service PTO driven equipment while thetractor engine is running.• Make certain all PTO shields

7SAFETY LABELSSTARTING INSTRUCTIONS1.KNOW THE OPERATING AND SAFETY INSTRUCTIONS IN THEOPERATORS'S MANUAL AND ON THE TRACTOR.2.MOVE THROTTLE TO M

8SAFETY LABELS (Cont.)WARNINGFAILURE TO FOLLOW ANY OF THE INSTRUCTIONS ABOVE CAN CAUSE SERIOUS INJURY TO THE OPERATOR, OR OTHER PERSONS.To avoid pers

9SECTION 1: CONTROLS AND FEATURESFLOORBOARD AND DASH PANEL MOUNTED CONTROLSFigure 1 BCDEFGHJKLMAABCDEFGHJKLMSteering WheelPTO SwitchThrottle HandleI