Cub Cadet GT1554 Manual del operador Pagina 8
- Pagina / 72
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Tractor Set-Up
Moving The Tractor Manually
Your tractor’s transmission is equipped with a hydrostatic
relief valve for occasions when it is necessary to move the
tractor manually. Opening this valve permits the fluid in the
transmission to bypass its normal route, allowing the rear tires
to “freewheel.” To open the hydrostatic relief valve, proceed as
follows:
Locate the hydrostatic bypass rod in the rear of the tractor.
See Fig. 3-1.
Pull the hydrostatic bypass rod outward, then up, to lock it
in place.
NOTE: The transmission will NOT engage when the hydrostatic
bypass rod is pulled out. Return the rod to its normal position
prior to operating the tractor.
CAUTION: Never attempt to move the tractor
manually without first opening the hydrostatic relief
valve. Doing so will result in serious damage to the
tractor’s transmission.
1.
2.
Shipping Brace Removal
WARNING! Make sure the garden tractor’s engine
is off, set the parking brake and remove the ignition
key before removing the shipping brace.
Locate the shipping brace, if present, and warning tag
found on the right side of the cutting deck. See Fig. 3-2.
While holding the discharge chute with your left hand,
remove the shipping brace with your right hand by
grasping it between your thumb and index finger and
rotating it clockwise.
WARNING! The shipping brace is used for
packaging purposes only. Remove and discard the
shipping brace before operating your garden
tractor.
WARNING! The mowing deck is capable of
throwing objects. Failure to operate the riding
mower without the discharge cover in the proper
operating position could result in serious personal
injury and/or property damage.
1.
2.
Figure 3-2
Figure 3-1
Contents of Crate
One Garden Tractor• One Oil Drain Tube• One Deck Wash Hose Coupler•
One Garden Tractor Operator’s
Manual
• One Kohler Engine Operator’s
Manual
• One Product Registration Card•
Assembly & Set-Up
3
8
- OperatOr’s Manual 1
- To The Owner 2
- General Operation 3
- CALIFORNIA PROPOSITION 65 3
- Slope Operation 4
- Do Not: 4
- Children 5
- Safe Handling of Gasoline: 5
- General Service 5
- Do not modify engine 6
- Notice Regarding Emissions 6
- Spark Arrestor 6
- Average Useful Life 6
- SAVE THESE INSTRUCTIONS! 6
- Assembly & Set-Up 8
- Checking Tire Pressure 9
- Adjusting the Seat 10
- Gas and Oil 10
- Controls and Features 11
- PTO / Blade Engage Knob 13
- Parking Brake Lever 14
- Cruise Control Lever 14
- Operation 15
- Driving The Tractor 16
- Reverse Caution Mode 16
- Driving On Slopes 17
- Engaging the Parking Brake 17
- Setting The Cruise Control 17
- Using the Deck Lift Lever 17
- Operating the Headlights 17
- Engaging the PTO 18
- Maintenance & Adjustments 19
- Cleaning the Tractor 20
- Lubrication 20
- Adjustments 21
- Parking Brake Adjustment 22
- Steering Adjustment 22
- Maintenance Schedule 23
- Maintenance Log 24
- Cutting Deck Removal 25
- Cutting Blades 26
- Jump Starting 27
- Charging 27
- Changing the Deck Belt 28
- 29sectiOn 7 — service 29
- Troubleshooting 30
- Replacement Parts 31
- Attachments & Accessories 33
- CUB CADET LLC 36
- GDOC-100014 REV. B 36
- Manual del OperadOr 37
- Al propietario 38
- Funcionamiento general 39
- PROPOSICIÓN 65 DE CALIFORNIA 39
- Funcionamiento en pendientes 40
- Haga lo siguiente: 40
- No haga lo siguiente: 40
- Servicio 41
- No modifique el motor 42
- Aviso referido a emisiones 42
- Guardachispas 42
- Vida útil media 42
- GUARDE ESTAS INSTRUCCIONES 42
- Montaje y Configuración 44
- Ajuste del asiento 46
- Gasolina y aceite 46
- Controles y Características 47
- Perilla de potencia 49
- Palanca de freno de mano 50
- Palanca de control de crucero 50
- Funcionamiento 51
- Conducción del tractor 52
- 17sección 5— funciOnaMientO 53
- Corte de césped 54
- Mantenimiento y Ajustes 55
- Limpieza del tractor 56
- Lubricación 56
- Puntos de pivote y varillaje 57
- Ruedas de plataforma 57
- Husillo de plataforma 57
- Barra de 58
- Calendario de mantenimiento 59
- Registro de mantenimiento 60
- Cuchillas de corte 62
- Neumáticos 63
- 28 sección 7 — serviciO 64
- 29sección 7 — serviciO 65
- Solución de Problemas 66
- Piezas de reemplazo 67
- Repuesto sin cargo alguno 68
- Aditamentos y Accesorios 69
- DE SERIE 1000 Y SERIE 1500 72
Relacionado con productos y manuales para Herramientas De Jardín Cub Cadet GT1554
(28 paginas)
(53 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.083 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales