Cub Cadet BV 228 Manual del operador descargar pdf

769-07543 P00 01/12

NEED HELP? CALL 1-877-282-8684 IN U.S. OR 1–800–668–1238 IN CANADA

BV228 EC

2-Cycle

Electric Start Capable

Handheld Blower / Vacuum

IMPORTANT: READ OPERATOR’S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT.

Upper Blower Tube

Removing Unit From Carton

ssemble The Unit

Insert the upper blower

tube into the blower outlet

and turn it clockwise until

t locks into place.

nstall the lower blower tube

nto the upper blower tube

nd turn it clockwise until it

ocks into place.

tarting The Unit

Assemble The Unit

lace the unit on a level

urface. Fill the fuel tank.

rouch in the starting

position.

queeze and hold the

throttle for all further steps.

ull the rope 5 times.

Move the choke lever to

Position 2.

11 2

Remove all contents from

carton.

tarting The Unit

Need Help?

Call 1-877-282-8684

DIDN’T START?

Repeat the starting instructions.

IF engine fails to start after 2 attempts,

move choke lever to position 3 and pull

the starter rope until engine starts

IF unit still fails to start, refer to the

operator’s manual for additional starting

and troubleshooting information

Mix thoroughly in a separate

fuel can:

– 2.6 fl. oz. of 2-cycle

ngine oil

– 1 gallon of unleaded

asoline

OTE: Do not mix directly in

the fuel tank.

Starter Rope

n/Off Stop Control

Lower Blower Tube

rigger

Handle

ruise Control

tarting The Unit

Fuel Cap

rimer Bulb

Choke Lever

ower Vacuum Tube

pper Vacuum Tube

acuum Elbow

acuum Bag Strap

Cinch Strap

Vacuum Bag

ipper

ir Filter

Cover

Muffler

Cover

park Plug

Tools Required:

• Flathead Screwdriver

Gallon 2.6 oz

50:1

Press the primer bulb 10

times, or until fuel is visible.

ove the choke lever to

osition 1.

5 X

Continue to squeeze the

trigger, or press down the

cruise control, and allow the

unit to warm up for 30-60

seconds.

Continue to squeeze the

trigger. Move the choke

lever to Position 3. Warm

the unit for an additional 60

seconds. The unit may be

used during this time.

Continue to squeeze the

trigger. Pull the rope 3-5

times to start the engine.

3-5 X

113

10 X

Primer

ulb

Choke Lever

Español — Page 11

English — Page 1

Français — Page 5

Operator’s Manual

1 2 3 4 5 6 ... 15 16

Indice de contenidos

Pagina 1 - BV228 EC

769-07543 P00

Pagina 2 - SAVE THESE INSTRUCTIONS

10REMARQUES

Pagina 3 - OPERATING INSTRUCTIONS

¿NECESITA AYUDA? LLAME AL 1-877-282-8684 EN EE. UU., O AL 1–800–668–1238 EN CANADÁ769-07543 P00

Pagina 4

12• Evite los arranques accidentales. Debe estar en la posición de arranque siempre que tire de la cuerda. Eloperador y la unidad deben estar en una p

Pagina 5

13ENSAMBLAR LA UNIDADMONTAJE DE LA SOPLADORAInstalar el tubo superior de la sopladora1. Alinee el saliente del extremo del tubosuperior de la soplador

Pagina 6 - CONSERVEZ CES INSTRUCTIONS

REEMPLAZO DE LA BUJÍA DE ENCENDIDOUse una bujía de encendido 753-06193. La separación correcta es de 0,635 mm(0,025 po).1. Detenga el motor y déjelo e

Pagina 7 - ATTENTION :

15LIMPIEZA Use un cepillo pequeño para limpiar la parte exterior de la unidad. No utilice detergentes fuertes. Loslimpiadores caseros que contienen ac

Pagina 8 - INSTRUCTIONS D’UTILISATION

MANUFACTURER’S LIMITED WARRANTY FOR:GARANTIE LIMITÉE DU FABRICANT POUR:GARANTÍA LIMITADA DEL FABRICANTE PARA:The limited warranty set forth below is g

Pagina 9 - RÉSOLUTION DES PROBLÈMES

• Avoid accidental starting. Be in the starting position whenever pulling the starter rope. The operatorand unit must be in a stable position while st

Pagina 10 - REMARQUES

3ASSEMBLING THE UNITBLOWER ASSEMBLYInstalling the Upper Blower Tube1. Align the bump on the end of the upperblower tube with the bump slot on thebotto

Pagina 11

REPLACING THE SPARK PLUGUse a replacement part number 753-06193. The correct spark gap is 0.025 in.(0.635 mm).1. Stop the engine and allow it to cool.

Pagina 12 - GUARDE ESTAS INSTRUCCIONES

BESOIN D’AIDE ? POUR VOS QUESTIONS, APPELEZ LE 1-877-282-8684AUX É.-U. OU LE 1-800-668-1238 AU CANADA769-07543 P00

Pagina 13 - ROPORCIÓN - 50:1

6que le gravier, le sable, la poussière, l’herbe, etc. pourraient être entraînés par une prise d’air etéjectés par l’ouverture d’expulsion, et endomma

Pagina 14 - INSTRUCCIONES DE OPERACIÓN

7ASSEMBLER L’APPAREILASSEMBLAGE DU SOUFFLEURMise en place du tube de soufflagesupérieur1. Alignez la partie saillante sur l’extrémitédu tube de souffl

Pagina 15 - ACCESORIO OPCIONAL

REMPLACEMENT DE LA BOUGIE D’ALLUMAGEUtilisez une bougie 753-06193. L'écartement correct est de 0,635 mm (0,025 po).1. Arrêtez le moteur et laisse

Pagina 16 - CUB CADET LLC

9NETTOYAGE Utilisez une petite brosse pour nettoyer l’extérieur de l’appareil. N’utilisez pas de détergents agressifs. Desproduits d’entretien ménager